[1] |
IGLESIAS GARCIA S, FERREIRO GARCIA R, CARBIA CARRIL J, et al. A review of thermodynamic cycles used in low temperature recovery systems over the last twoyears[J]. Renewable and Sustainable Energy Reviews, 2018, 81:760-767. DOI: 10.1016/j.rser.2017.08.049.
doi: 10.1016/j.rser.2017.08.049
|
[2] |
VARMA G V P, SRINIVAS T. Parametric analysis of steam flashing in a power plant using waste heat of cementfactory[J]. Energy Procedia, 2016, 90:99-106. DOI: 10.1016/j.egypro.2016.11.174.
doi: 10.1016/j.egypro.2016.11.174
|
[3] |
WANG Q, WU W F, LI D T, et al. Thermodynamic analysis and optimization of four organic flash cycle systems for waste heat recovery[J]. Energy Conversion and Management, 2020, 221:113171. DOI: 10.1016/j.enconman.2020.113171.
doi: 10.1016/j.enconman.2020.113171
|
[4] |
OZA R D, SINNAMON J F. An experimental and analytical study of flash-boiling fuel injection[C]// SAE Technical Paper Series. 400 Commonwealth Drive,Warrendale, PA, United States: SAE International, 1983: 2948. DOI: 10.4271/830590.
doi: 10.4271/830590
|
[5] |
SERRAS-PEREIRA J, Van ROMUNDE Z, ALEIFERIS P G, et al. Cavitation, primary break-up and flash boiling of gasoline, Iso-octane and n-pentane with a real-size optical direct-injection nozzle[J]. Fuel, 2010, 89(9):2592-2607. DOI: 10.1016/j.fuel.2010.03.030.
doi: 10.1016/j.fuel.2010.03.030
|
[6] |
GÜNTHER A, WIRTH K E. Evaporation phenomena in superheated atomization and its impact on the generatedspray[J]. International Journal of Heat and Mass Transfer, 2013, 64:952-965. DOI: 10.1016/j.ijheatmasstransfer.2013.05.034.
doi: 10.1016/j.ijheatmasstransfer.2013.05.034
|
[7] |
LI S Y, ZHANG Y Y, XU B. Correlation analysis of superheated liquid jet breakup to bubble formation in a transparent slitnozzle[J]. Experimental Thermal and Fluid Science, 2015, 68:452-458. DOI: 10.1016/j.expthermflusci.2015.04.023.
doi: 10.1016/j.expthermflusci.2015.04.023
|
[8] |
ZHANG Y Y, LI S Y, ZHENG B, et al. Quantitative observation on breakup of superheated liquid jet using transparent slitnozzle[J]. Experimental Thermal and Fluid Science, 2015, 63:84-90. DOI: 10.1016/j.expthermflusci.2015.01.004.
doi: 10.1016/j.expthermflusci.2015.01.004
|
[9] |
WU S Q, PAN H J, XU M, et al. Investigation of rapid atomization and collapse of superheated liquid fuel spray under superheatedconditions[J]. Atomization and Sprays, 2016, 26(12):1361-1384. DOI: 10.1615/atomizspr.2016014231.
doi: 10.1615/atomizspr.2016014231
|
[10] |
WU S Q, XU M, HUNG D L S, et al. Effects of nozzle configuration on internal flow and primary jet breakup of flash boiling fuel sprays[J]. International Journal of Heat and Mass Transfer, 2017, 110:730-738. DOI: 10.1016/j.ijheatmasstransfer.2017.03.073.
doi: 10.1016/j.ijheatmasstransfer.2017.03.073
|
[11] |
WU S Q, XU M, HUNG D L S, et al. In-nozzle flow investigation of flash boiling fuel sprays[J]. Applied Thermal Engineering, 2017, 117:644-651. DOI: 10.1016/j.applthermaleng.2016.12.105.
doi: 10.1016/j.applthermaleng.2016.12.105
|
[12] |
MAKSIC S, MEWES D. CFD-calculation of the flashing flow in pipes and nozzles[C]// Proceedings of ASME 2002 Joint US-European Fluids Engineering Division Conference, Montreal, Quebec, Canada:Fluids Engineerirg Division. 2009: 511-516. DOI: 10.1115/FEDSM2002-31033.
doi: 10.1115/FEDSM2002-31033
|
[13] |
JANET J P, LIAO Y X, LUCAS D. Heterogeneous nucleation in CFD simulation of flashing flows in converging-divergingnozzles[J]. International Journal of Multiphase Flow, 2015, 74:106-117. DOI: 10.1016/j.ijmultiphaseflow.2015.04.005.
doi: 10.1016/j.ijmultiphaseflow.2015.04.005
|
[14] |
PALAU-SALVADOR G, GONZALEZ ALTOZANO P, ARVIZA-VALVERDE J. Numerical modeling ofcavitating flows for simple geometries using FLUENT V6.1[J]. Spanish Journal of Agricultural Research, 2007, 5(4):460. DOI: 10.5424/sjar/2007054-269.
doi: 10.5424/sjar/2007054-269
|
[15] |
INGLE R, RAO V S, MOHAN L S, et al. Modelling of flashing in capillary tubes using homogeneous equilibrium approach[J]. Procedia IUTAM, 2015, 15:286-292. DOI: 10.1016/j.piutam.2015.04.040.
doi: 10.1016/j.piutam.2015.04.040
|